
This card was created using the Stampin Up Blessed Easter Stamp set and the sentiment is from the wetlands stamp set. The back ground is created using the Venetian Romance Designer Series Paper.
Products Used:
Tangerine Tango Card Stock,
Venetian Romance Card Stock, item #130144
Blessed Easter Stamp Set, item #133212
Wetlands Stamp Set, item #126697
Very Vanilla Cardstock, item #101650
Blender Pen, item #102845
Stampin Dimensionals, item #104430
Tangerine Tango Classic Ink
Daffodil Delight Classic Ink
Old Olive Classic Ink
Stazon Black Ink
Instructions:
Cut tangerine tango cardstock in half, 8 1/2 x 5 1/2 and fold in half to form a card
Cut Venetian Romance DSP 4 x 5 1/4 and layer on front panel of card
Cut another piece of Tangerine Tango 2 7/8 x3 1/8, for focal image base
Cut a piece of Very Vanilla cardstock 2 3/4 x 4″, stamp the tulip stamp from the blessed Easter stamp set onto the left side of the focal panel. Then stamp your sentiment.
cut some 1/4″ ribbon to 9″ and fold in half
Layer the folded ribbon leaving the tails showing and glue it under the 2 3/4 very vanilla focal image piece. Attach the ribbon and focal image on top of the tangerine tango cardstock focal image base
Next stamp on scrap very vanilla cards stock 2 tulip images in stazon black, color them using tangerine tango classic ink and the daffodil delight ink for highlights. You can us the blender pen to give it a water color effect by taking the blender pen and dip it into the ink pad lid ( use a closed ink pad and press down on the lid to transfer ink from the pad to the lid) or if you have the refills just use a drop on your craft mat and dip the blender pen tip in the ink and color. ( be careful not to over saturate your paper so you don’t cause it to rip) Use the same technique to color in the stems and leaves with Old Olive classic ink, Cut out the images and set aside.
Now pop up the focal image using the stampin dimensional and add the cut out tulip image on top of the stamped image also using stampin dimensionals
For the inside of the card cut a base card of very vanilla, 4 x 5 1/4, center and glue to card,
at the bottom cut and glue a 4 x 1″ piece of Venitian Romance DSP.
Finally add the other cut out tulip and glue it to the left bottom corner and enjoy.
Check out the Gallery for more card ideas